Hello,
Noob here.
Finally bought the software, and then updated the Lightburn Software. I am running a snapmaker 2.0 A350 with a 10w laser
Now all my new output files resize to really freaking small…
-I.e. an object that should be 100mm by 100mm is read by my Snapmaker as 2mm x 2mm.
It does it with items I ran two days ago before the I purchased and updated the software.
Sometimes when I run the boundary, it will move in the full size boundary, but not from origin.
-I.e. It will be offset x+25 and y-30 (example only, it is all over the place)
I looked all over youtube for a solution and these forums. Nothing really comes up. Any Help would be appreciated.
I have attached a few pictures. The drawing showing the origin, in Lightburn, Luban(meh), and on the work piece. It the work piece you can see where it cut just fine a few days ago. I also have a link to the video showing how it moves runs offset from the origin of work.
