Upgrade changed all my Speed setting X 60

I having a problem with the upgrade? all My speed setting from an old file have increased by a factor of 60.

I have a K40 with a Mini Gerbil v2 board and after deleting the profile and refinding new laser all my speed have increased by a factor of 60
My acylic cutting speed was 5mm per sec and now when I open the same file it show 300mm per sec?
what changed? is there a place to reset this value. All my speed have increased by a factor of 60.

Andrew Deak

Are you certain the units did not change? A factor of 60 increase would normally imply that you went from units in minutes to now units in seconds.

2 Likes

fixed, I do not know how the setting changed

Close

Andrew

1 Like

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.