Upgrade problem

[BrianF84 (Brian)]

Hey Lee,

please try this:

MAJOR Update 1.0 problem

(We addressed this over email, but I’ll summarize here) $32=1 is the setting to use to enable laser mode. The summary of the issue is that Franklin had ‘Fast Whitespace’ enabled, but the speed set to 0, and had laser mode disabled. The previous versions of LightBurn would ignore the ‘fast whitespace’ setting if you didn’t give it a speed. The new version treats 0 as “go as fast as allowed”, so it uses G0 moves to traverse through whitespace. If you don’t have the controller in Laser Mode ($…

Good luck and cheers,
Brian