Starting stream
Layer C01 Pass 1 of 3
Layer C01 Pass 2 of 3
ALARM:2
G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)
On or near line 4:
Job halted
Stream completed in 0:00
[MSG:Reset to continue]
ok
Ortur Laser Master 2 Pro S2 Ready!
OLF:OLF 185.
OLH:OLM_ESP_PRO_V1.2.
OLM: GENERAL.
[MSG: Flame detector active,Ambient infrared value:0]
Grbl 1.1f [‘$’ for help]
[MSG:‘$H’|‘$X’ to unlock]
[MSG:Caution: Unlocked]
ok
I think your zero-position is not set / wrong. Have a look here: Coordinates & Origin - LightBurn Software Documentation and maybe as well here: Coordinate systems - Diode Laser Wiki
For Ortur lasers the answer is typically to upgrade to the latest firmware. Older firmware somehow had issues with offsets getting set in unpredictable ways.
2 Likes
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.