My brand new test device Wainlux K8 has some kind of GRBL ESP32 controller.
It connects to my home LAN via WIFI and always gets the same IP address provided.
The proprietary Software CutLabX connects to the printer without problems.
In Lightburn (newest version) I configured a new device GRBL, LAN … .
But: It stays disconnected.
Somebody any idea?
Same issue here. I can’t connect via USB either. Only way I can connect is via the device’s WIFI using CutLabX.
Did you install the driver?
So I have issues with it on the included software where the camera is producing a weir picture which is like a mirror. The image during calibration was fine. I tried using lightburn, and the laser will connect using GRBL but the camera won’t come up. Is there not a way to connect via wi-fi in lightburn?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.