I initially attempted to correct the ‘wavy lines’ that I was experiencing during several of my engravings and had adjusted several settings that I saw in other forum posts, however, on one of the last adjustments my laser’s functions began acting completely different. For example, it’ll run past the limits when homing or going to the origin, won’t plot, and my laser is saying that my 0,0 is not in the bottom left corner despite being selected. Can someone assist me in informing me what my laser’s console values should be?
Some information:
Laser: Atomstack X7 Pro 50W
Lightburn v1.1.03
Controller: GRBL
$$
$0=10
$1=25
$2=0
$3=4
$4=1
$5=1
$6=1
$10=1
$11=0.010
$12=0.002
$13=0
$20=1
$21=1
$22=1
$23=0
$24=300.000
$25=3000.000
$26=250.000
$27=1.000
$30=1000.000
$31=0.000
$32=1
$37=0
$100=80.000
$101=80.000
$102=80.000
$103=100.000
$104=100.000
$105=100.000
$110=6000.000
$111=6000.000
$112=6000.000
$113=1000.000
$114=1000.000
$115=1000.000
$120=1000.000
$121=1000.000
$122=1000.000
$123=200.000
$124=200.000
$125=200.000
$130=410.000
$131=400.000
$132=200.000
$133=300.000
$134=300.000
$135=300.000
Thank you