I have a ortur laser master 3 . I recently hooked up the YRR 2.0 and was working on tumblers. When I disconnected it reconnected the y motor and reverted settings back to before i switched . When I start laser with Y motor on the laser returns home and starts clicking loudly.I’ve checked all setting in lightburn and they match what on ortur GrBL PDF on website.
I’ve also updated firmware on device
Here is the message in lightburn
Home|MPos:0.000,0.000,0.000|Bf:63,32767|FS:0,0|CL:0,0|PS:2,0|WCO:0.000,0.000,0.000|VA:23656,17|A:SFM>
[GC:G1 G54 G17 G21 G90 G94 G49 G98 G50 M5 M9 T0 F2700 S0.]
<Home|MPos:0.000,0.000,0.000|Bf:63,32767|FS:1131,0|CL:0,0|PS:2,0|VA:23656,17|Ov:100,100,100|A:SFM>
<Home|MPos:-39.960,-39.960,0.000|Bf:63,32767|FS:1131,0|CL:0,0|PS:2,0>
<Home|MPos:-79.970,-79.970,0.000|Bf:63,32767|FS:1131,0|CL:0,0|PS:2,0>
<Home|MPos:-119.980,-119.980,0.000|Bf:63,32767|FS:1131,0|CL:0,0|PS:2,0>
<Home|MPos:-160.000,-160.000,0.000|Bf:63,32767|FS:1131,0|CL:0,0|PS:2,0>
<Home|MPos:2.300,2.300,0.000|Bf:63,32767|FS:1131,0|CL:0,0|PS:2,0>