Wher can i faind the g-code for sculpfun s9 90w

[adnan662 (Adnan Gari)]

i have that msg wher can i faind the g-code for sculpfun s9 90w…?
G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)

On or near line 12:

Job halted

Stream completed in 0:00

[MSG:Reset to continue]

[berainlb (PY)]

Push “Save Gcode” in Laser window to save g-code.

For this error the most common causes are 2 things:

1. Make sure you don’t turn on the laser until you place the laser head at the front-left of the machine. After powering on, never move the laser head by hand. Always use jogging controsl.
2. Use Absolute Coords in Start from mode in Laser window

[adnan662 (Adnan Gari)]

error:9
error:9
G-code locked out during alarm or jog state.

[adnan662 (Adnan Gari)]

Starting stream

Layer C00

ALARM:2

G-code motion target exceeds machine travel. Machine position safely retained. Alarm may be unlocked. (Right-click the ‘Devices’ button to reset the connection)

On or near line 4:

Job halted

Stream completed in 0:00

[MSG:Reset to continue]

ok

Grbl 1.1h [‘$’ for help]

[MSG:‘$H’|‘$X’ to unlock]

[MSG:Caution: Unlocked]

ok

[berainlb (PY)]

Can you provide some context for these messages? Did you try anything?