Depending on what you were doing this could definitely be changing your offsets.
This is not what I expected at all.
Can you rerun the commands one at a time and then return output?
1 Like
sorry when you say run them one at a time do you mean like this?
$H
G10 L20 P1 X0
$#
ok
ok
ok
[G54:-850.004,-859.992,-42.743]
[G55:-788.909,-620.147,-63.950]
[G56:-808.896,-62.212,-12.750]
[G57:0.000,0.000,0.000]
[G58:0.000,0.000,0.000]
[G59:0.000,0.000,0.000]
[G28:0.000,0.000,0.000]
[G30:0.000,0.000,0.000]
[G92:0.000,0.000,0.000]
[TLO:0.000]
[PRB:0.000,0.000,0.000:0]
ok
$H
G10 L20 P1 Y855
$#
?
<Home|WPos:0.000,855.000,37.743|FS:0,0|WCO:-850.004,-859.992,-42.743>
ok
ok
ok
ok
[G54:-850.004,-859.992,-42.743]
[G55:-788.909,-620.147,-63.950]
[G56:-808.896,-62.212,-12.750]
[G57:0.000,0.000,0.000]
[G58:0.000,0.000,0.000]
[G59:0.000,0.000,0.000]
[G28:0.000,0.000,0.000]
[G30:0.000,0.000,0.000]
[G92:0.000,0.000,0.000]
[TLO:0.000]
[PRB:0.000,0.000,0.000:0]
I think this got there. I meant to run one command/line at a time.
This is the result I expected.
If you ever experience this issue again go through the same steps. Alternatively, you could do this without having to home first by running this command:
G10 L2 P1 X-850.004Y-859.992
In any case, I think you should be back to a working state. Can you test and report back results please?
1 Like
sorry for the confusion lol but YEP! its working again thanks again appreciate it very much
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.