Wire broke off on sculpfun s9 laser module circuit board

I was cleaning the buildup of smoke/dust etc from the fan control when i noticed the wire had broken off of the circuit board. Has this happened to anyone before? Where you able to repair it with Solder or a circuit board repair place?

I am in the middle of making some Christmas gifts for customers and i can’t find another s9 module for sale and s10s are sold out.


Why don’t you just solder it back on??
Another time you clean your electronics, use dry compressed air, (block your fan so it doesn’t run wild), it’s the safest, fastest and easiest way to do it, in my opinion.

I had the same thing happen to me. I re-soldered the wires and then extended them.

Thank you!

This a great idea, thank you, time to go buy a soldering gun.

I highly advise you to clean that board before soldering or you may have a bad time. At least the contact that you’re resoldering. Get some flux and fresh solder as well.