ok here we go. I have upgrade my cnc2-5040 to include a woodpecker V3.4 control board and limit switches. I am running on Grbl 1.1f with LightBurn 0.9.23. I have been able to figure out how to get the laser to home in the right rear. but when I try to frame a project it moves to the front and left till it hits one of the hard limit switches.this same thing happens when I put x 1 y 1 then hit move. what setting am I missing. also have already added G10 L2 P1 x-500 Y-400 to get it to go to front left
ok
$0=10
$1=25
$2=0
$3=2
$4=0
$5=0
$6=0
$10=0
$11=0.010
$12=0.002
$13=0
$20=1
$21=1
$22=1
$23=0
$24=25.000
$25=500.000
$26=250
$27=1.000
$30=1000
$31=0
$32=1
$100=800.000
$101=800.000
$102=800.000
$110=1000.000
$111=1000.000
$112=600.000
$120=30.000
$121=30.000
$122=30.000
$130=500.000
$131=400.000
$132=200.000
ok