Work area, and calibration settings

[MrOrange (Andrew Orange)]

It seems that my work surface on the computer screen doses not match that of my engraver. I have deleted the engraver and reinstalled with the measurements of the actual area of the engraver, but when I go to the middle of the work area on the computer screen the laser hammers the opposite boarder of the frame.

I have tried to correct the issue thru X & Y calibration, but now the engraver is going in all directions, firing the laser at full power and locking up.

I am using a GRBL BACHIN laser.

This all started because I was trying to get both work surfaces to match… pls direct me to a solution… very frustrated

[Rick (Technical Evangelist)]

Here is a good place to start:

https://lightburnsoftware.github.io/NewDocs/CommonGrblSetups.html

You can also type “$$” into the Console, and hit Enter/Return, then copy and paste what gets spit out here for review.

[MrOrange (Andrew Orange)]