Work with fine detail

[cggorman (Chris)]

If normal optimization settings don’t help, consider using sub-layers to further refine.

And, as always, use preview playback mode to reduce scrap while tinkering with this type of thing

Lightburn Super Trick

Hello to all. Instead of making multi-pass cuts in intricate details where laser burns the same segment over and over again and that sometimes leads to material burn… You can automatically make 1 pass cut plus 1 pass cut plus 1 pass cut and so on to let material cool a bit. Using Lightburn sub-layers like in the enclosed example. It take a few seconds more but gives much better results. At the end of the job start the job again (3 times in this case) or use cut job with 9 cloned sub-layers, …