Workspace offline setup for laser module on 3D printer

Hello everyone.
I have a Creality Falcon 10W laser module on a custom mount on an Ender 3v2.
The physical workspace is 230x230mm, and the laser starts out centered correctly at x=0.
However, because of how it’s mounted, the laser starts off at around y=-20mm in the home position. So, outside the work area.
This means at machine coordinates y=230, the laser would be at y=210.

I currently use a microSD card to move between PC and laser.
Is there a way to adjust the software side to tell LightBurn “hey, please do not laser the first few mm, work area only starts after moving Y a few mm”?

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.