X tool S1 - Autofocus programm head

[exic (Michael)]

Hi,

is it possible to do an automatic Autofocus? I want to messure the thickness everytime when I start a program.

In the factory macro is only M368 but when I run it Lightburn showes
M311 T0
M311 R0
M313 Z …
ok
ok
ok
M311 T2
M311R2

I tried to add M368 in the first line of the head but it only moves to “push the pin back in” position. I asked the xtool support as well.

I will try a few other ways tommorrow. Thank you for your answers.

Best regards
Michael

[exic (Michael)]

So far, but not good…

I trued some things in the code but nothing really works.

the xtool support says “use XCS, lightburn does not suppert every function of xtool lasers” but on the product page is lightburn shown as supported.

I’m disappointed that a basic function of modern lasers shouldn’t be possible…