Xtool D1 PRO 20W doesn't engrave in Lightburn but works in XCS

Hello everybody!

My Xtool D1 PRO 20W machine Doesn’t engrave in Lighburn but works well in the XCS program.

When I have started the engrave in Lightburn the laser went to the home position, the laser doest’t fire just the fun worked. The softwer showed that the engrave gone well.

Any solution?

Hi.

With xTool products anything is possible, but we do need more information in order to help You.

Has Your xTool D1 Pro worked with LB before?
If it has, what happened just before it stopped working?

If it hasn’t, have You followed these:

instructions?

That doesn’t mean anything, with D1 Pro and similar lasers (and engravers), the software like LB -and XCS for that matter- just sends the whole program on to the controller and it is run from there.

Regards,
Sam

:finland:

This topic was automatically closed after 30 days. New replies are no longer allowed.