Hello. I am new to this and have tried two XTool D1 Pros, and while I can get them to cut from multiple origins, I have never been successful getting them to home. I send click the home command in LightBurn and it gets to the homing switch and stops, setting one limit switch trigger, and never proceding to the next one. Overall it is not using the switches to trigger it towards setting it home. Here is what I see on the console:
ok
[XTool D1Pro:ver 40.31.001.01 B8]
ok
start_home x
enable x limit
start_home y
enable y limit
Lim_up: 1
y limit trigged
MPos:0.000000,0.000000,0.000000