LightBurn Software Forum

Xtool M1 Compatibility

LightBurn Hardware Compatibility

berainlb (PY) July 23, 2023, 7:43am 2

These are relevant:

Support for xTool M1? xTool D1

I’m using this all the time to work with LightBurn on the M1. The ability to control the M1 directly from LightBurn is still missing because we have found no way to get the current position from the M1, and LB requires that. But exporting a G-Code file and framing / cutting that with m1control.py works fine. Only work placement is a bit finicky because I could not get the camera stream into LightBurn yet. So you have to frame, check, and adjust, until it fits. Also, you might want to tune the …

support.xtool.com

How to Use LightBurn on M1? - xTool Support Center

Section 1: Generate Gcode in LightBurn STEP1: DOWNLOAD AND INSTALL LIGHTBURNhttps://Lightburnsoftware.com/pages/trial-version-try-before-you-buy STEP 2: BEFORE YOU CONFIGURE XTOOL M1, DOWNLO

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled