I see that “XTool Network Protocol Support” has been added in LightBurn-v2.2.00-RC-2, how do I connect to my XTool -S1, I Get an error “xTool: cannot determine protocol generation at IP192.168.------ (no V1 service on :8080, nothing listening on :28900); retrying in 1s (attempt 1)” xTool Studio …

The S1 and D1 only work over serial for now. I added that detail to the RC-2 release post . Here’s the latest device profile that should work: S1-40w.lbzip (2.0 KB) Drag this file to the workarea to add it.

Adding my voice here — xTool F2 Ultra owner (60W MOPA). Would love to see the F2 Ultra added to the network-protocol device list. It speaks the same V2 protocol family as the F1, so hoping it’s a straightforward add. Happy to beta test if you need F2 Ultra testers. Thanks!

Thanks for chiming in, and welcome to the forum, @Td3d I’ve only heard the devs talk about the F1 so far, but I see the F2 is on the list in the Device Settings, under “Device Classification”. That’s just the list of detectable machines. It should reset on each new connection. If you connect to a…

@Td3d Got feedback from the devs: It definitely won’t work right now because I haven’t filled out the metadata table for the F2. If the F2 Ultra and F1 speak the same V2 protocol family as the F1, that would would be really lovely! We can turn it on and treat the F2 like the F1, might as well, …

Happy to help — I’ll run M99 and send you the output. One snag: my trial just expired and I’ve hit the extension limit, so I can’t launch LightBurn at all right now. Any chance you can hook me up with a trial extension or a test key so I can get you that M99 reply?

[image] Td3d: Any chance you can hook me up with a trial extension Yes. Please send me the Trial ID in a direct message, so I can look into it.

Looking to see where this landed with F2 ultra. My trial is expired and want to see if there is finally support for the F2 before purchasing.

Hi Steve, Welcome to the forum! We don’t have access to an F2 Ultra to test it with the new xTool protocol, so your offer is very welcome. Please send us your Trial ID in an email to support@lightburnsoftware.com (mention this forum thread.) I’ll extend it for you and will have further instructio…

Hey Aaron — i sent my Trial ID over to support@lightburnsoftware.com . Happy to help run whatever tests you need.

LightBurn Software Forum

XTool Network Protocol Support

LightBurn Hardware Compatibility xTool

xtool

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled