XTOOL RA2 setup with fiber laser stuttering issue

LightBurn Hardware Compatibility
,
1

Hello everyone

I have a 100watts JPT MOPA fiber laser and I purchased Xtool RA2 tool but it is just stuttering. Driver board in the laser is set to 6400 pulses via dipswitches. whatever I tried RA2 is just stuttering but nothing.

Is there anyone use Xtool RA2 without any issues with fiber laser? May be some point I am missing for a correct rotary setup for RA2

thanks in advance…

2

If it’s only stuttering, the wires of the cable are not in correct order. Start by swapping the two inner wires, then try again.

2 Likes