Hello all. Fairly new to lasers. I’ve been using Lightburn on my S1 for about 2 months now and I love it. However, I seem to be having a strange issue where my laser module will get stuck on the very first operation after turning on the laser. It will frame out fine and then when I go to process the actual job, it will start and then the gantry will just stop moving with the laser still firing. It will stay like this for a few seconds and then it will shut off and the job stops. Every time this has happened, all I have to do is shut the laser off, wait 30 seconds and turn it back on. I can then refocus and run the job without issue. This only happens when using the S1 in Lightburn. I also run XCS at times and have never had this issue. I’m on 1.7.04 and the latest firmware version from xTool. I will say this has been happening since I was on 1.7.0 and through a few firmware updates from xTool. Any thoughts or feedback would be appreciated.
To help us post a screenshot of your devjce settings and one from the GCode tab.
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.