The ‘grid’ in my version of Lightburn (2.1.04) is offset to the right so that x 0 on the grid is at least 30mm on the actual honeycomb. How can I adjust this so that I can cut material much closer to the left had edge of the honeycomb?

When you Home the machine, where does it go? Is it in the corner of the honeycomb, or is it 30mm from the honeycomb frame corner?

[image] HenryM: 30mm on the actual honeycomb. [image] The S1 does have a pointer offset. Are you following the installation instructions from here: [image] Setting up xTool S1 with new xTool device type in LB 1.7 and Beyond xTool This device type doe…

**Thank you. The honeycomb which has x and y scale measuring 513x and 323y is moved to the right and bottom of the ‘base’. When I use the Home button the laser moves so that the red cross is 20mm from the left and 17mm from the top of the honeycomb and the values in the Get Position are 0x 0y. I …

The only way I know to get them aligned in your case is to: Home the machine. Set Zero for X & Y. Select Absolute Coords. Jog over so that the laser is exactly in the front left corner of the honeycomb. Record the X & Y coordinates for future reference. You can use them in a Macro for lster startu…