This only happens on the Xtool S1 using lightburn.
I have the lates 17. 0.1 installed and I can’t believe this still hasn’t been fixed.
Go to cut and it cuts a line directly through the design for no reason at all
Report it to xTool. They have messed up the firmware. LB team does best to support it, but xTool doesn’t seem to be interested in supporting this well (as far as I have heard).
If you buy an xTool laser, use XCS. Or use LightBurn and buy a laser from a company that supports “open” standards (which is everyone else except xTool, mostly) .
.