ソフト上での操作y軸が逆に進む対処法？

[berainlb (PY)]

This post is relevant.

Cutting direction does not match origin

Good day, I made my own cutting machine using mks dlc32 v2.1 and lasertree k40. I used Nema 23 stepper motor and TB6600 drivers. My mechanical and electrical installations were completed without any problems. However, when it came to routing with Lightburn software, there was a problem that I could not overcome. I want to set the zero point of my machine as the upper right, but I could not match the directions of the direction keys on the TS35R with the movement keys on the Lightburn. However, …