I’m doing my first test with lightburn with the 30 days trial. Your soft is perfect but I have no check mark to activate the Z axis, I use a controller dsp 608,
I will have a large order where I need to change the Z axis position bewteen 2 layers
We can’t control Z axis with lightburn currently ?
Have a got a approximate date with this update ?
Thank you
1 Like
As far as I know, Trocen controllers do not have the ability to alter the Z axis during a cut. I have found nothing in LaserCAD that will do this, so I have sent a message to Trocen to ask if this is even possible, and if so, if they will share the commands with me to do so.
+1 for me, I need also to adjust the Z offset
Regards, Olivier
1 Like
Ok thank you for telling us the trocen’s feedback
Otherwise I will probably have to buy a Riuda in the following months
Thank you
Trocen has responded - there is no way to do this with their hardware.
Too bad, thank you for your quick feedback
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.