I have set the official config file for the xtool P2 in lightburn. I followed the instructions to change the start gcode. When I assign a material to the layer it auto set the Z one time and makes a good cut. The Z axis will never move again on other cuts even if I reassign the material to the layer. Has anyone gotten this to work in Lightburn?
Please share the start gcode. I have not seen these instructions.
I’ll ask internally if an xTool P2 has arrived here.
1 Like
I have one - the Z height is definitely a bit funky. Working on it now.
3 Likes
Start Gcode
$L
G90
;M116A2B4
G0Z(22)
End Gcode
;M116A127B127
M6
Link to instructions from xTool
https://makeblock.feishu.cn/docx/A9phddvVaoZHxhx7E0Rc0X2znGg
1 Like
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.