So I was trying to use Z offset to back the heigh off a bit when doing my thinner line to get that “scored” look. It’s a bunch of little words in a circle that are all in one group/clickable at once, but it is bumping the poor table for each and every letter. Noticed same behavior when I have a bunch of shapes, all grouped, same layer, it goes up and down between doing each of them in a row. Is there anyway to convince it to just chill out and stay at the new height for the entire grouped layer cut instead of bouncing up and down? (Does that make sense?!)
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.