Z Step Pass Issue

Have a Ruida Controller, Z-step works however it only allows it to step in a negative direction, I want to pull the laser out of focus on the second pass.

FYI, Focus test works great and I can jog in all directions.

I didn’t expect anyone would use it that way, but it’d be easy enough to add the ability to do that.

Anyone engraving rowmark or similar plastic would benefit from this. We typically like to pull the laser out of focus 1mm or so to clean up the engraving area on the second pass.

It’s been added already for the next release.

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.