Zero clearance insert for my Bosch GTS 635-216 table saw

Layered 3 pieces of 3 mm plywood. With a functioning lock that can be used from the top with a screwdriver.



9 Likes

A unique work. Thank you. I really took that into my notes.

Layered 3 pieces of 3 mm plywood. With a functioning lock that can be used from the top with a screwdriver.

Could you please send me a pdf file of the templates? :slight_smile:

Funny, but really its not. I just thought about this last week because I was using table saw to rough cut some acrylic for a project before I put it to the router and low and behold if a small piece didnt get pulled down and thrown right back at me. 7 stitches later, here I am. Its on my list but need to finish a project first (no worries, no need for table saw the rest of the way on this project)

Great job on these

1 Like

That is a great idea. I have a woodshop and the laser in in there too. I never thought of doing that.