Absolutely will not frame where it says it should

[Stroonzo (Jeff)]

At any point in your process has the distance from the Top of Material (ToM) to your camera changed? If so, that is your problem. See this thread:

Camera alignment is accurate only with the 4 targets but not anything else you add

I have a diode laser ortur master 2 15w. I installed a camera dead all the steps successfully all the images taken were under 0.09 except for a couple that were 0.12. when I jog the laser to the 4 targets they go right in the center but when I put an object in the middle and select the top corner it jogs about an inch away from it. What can I do to fix this