Hello,
I’m having the same issue as mentioned in this thread, and I was wondering if there was a conclusion about if the settings mentioned in RDWorks can be made available in Lightburn (mentioned here). After reading the last post in that thread I would very much like to avoid installing RDWorks if at all possible.
Just ran into this same issue yesterday. Had to use RDWorks to change the setting. Agree, it would be fantastic if this setting could be added to the machine settings in Lightburn.
There’s more information in this thread. If you’re on linux and feeling adventurous I could probably figure out a command that would send the right UDP packet without having to install rdworks.
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.