Hi,
i read all the post about this problem, but i coudn’t find it out.
i start to laser a wood pice. But lightburn gifs allways this:
Homing
ok
Starting stream
ALARM:2
On or near line 2:
Stream completed in 0:00
[MSG:Reset to continue]
i checked the laser and plug in, they are all correct.
and it doesen’t find my laser:
this happen if i enter (Doller)#:
[G54:-400.000,-430.000,0.000]
[G55:0.000,0.000,0.000]
[G56:0.000,0.000,0.000]
[G57:0.000,0.000,0.000]
[G58:0.000,0.000,0.000]
[G59:0.000,0.000,0.000]
[G28:0.000,0.000,0.000]
[G30:0.000,0.000,0.000]
[G92:0.000,0.000,0.000]
[TLO:0.000]
[PRB:0.000,0.000,0.000:0]
ok
now it found my laser but again the same problem with alarm 2:
and its doesen’t matter, what i want to laser if 1 letter or a picture.