Alignment within lightburn

[Beasyoe39 (Brian)]

I use CNC 3018 5.5 laser. I start in current position. But I get the pop up that says out of bounds and my image is center within my work area

[Rick (Technical Evangelist)]

Do you have limit switches on your setup?

Have a read here to get started.

Cut might be out of bounds - continue anyway?

on version 0.8.06 I get this pretty annoying nag every time I cut: “Cut might be out of bounds - continue anyway?” I use job origin, I have no home or limit switched, I don’t use home, and I cut from the center of my 850x410 cutting area. I can cut a 10mmx10mm square and I still get this popup. How can I make it go away permanently? Machine: OpenGuilds ACRO - GRBL 1.1 Also for the support team: I don’t think I have an “offset applied” - unless it’s something that automatically happens. Since…

[Beasyoe39 (Brian)]

I do not have a limit switch setup…Thanks