Tatay55
March 13, 2022, 2:41am
1
Not sure why but the prints are coming out skewed with or without using the mask…
JohnJohn
March 14, 2022, 7:39am
2
I’m not quite sure what you’re asking. You can upload pics in a reply by drag and drop or the Up-arrow icon on the reply window.
This may help you get to the information you’re looking for:
Folks,
When asking for support for LightBurn via this forum, email or anywhere else, please keep the following tips in mind for the fastest and most helpful answers.
controller does it have , and what firmware it is running?
Are you running the latest version of LightBurn?
Is the issue new, or has it happened before? What kind of computer is it, and what Operating System is it running?
Tatay55
March 24, 2022, 12:03am
4
I finally figured it out for some reason it was reading 390 instead of 410mm reset the belt and tightened it then I reset the value for 410 homed it and it works fine now.