Atomstack R1 rotary on Commarker B4 Fiber

[jkwilborn (Jack Wilborn)]

You don’t mention if it’s a chuck or roller rotary.

Sounds like you don’t have the steps/rotation set correctly.

A rotary attachment question. Warning: Newb

Configuring for a rotary should not be an issue. I’m assuming you are using the Y axes… you didn’t say… find steps/rotation a. identify the switch settings b. translate from the motor driver placard steps/rotation is then computed based on a ratio. a. value entered is steps/rotation multiplied by the ratio which results in the steps/rotation of the wheel, which is what Lightburn needs to know. This is the basic procedure. [motor-driver-switches] Look up the settings on the devices pla…

---

If the issues it setting the DM542 module up, please advise.

If you still have issues, sing out