Back with the Same Issue... Lightburn on Mac Cannot Find Laser

[krisgamble]

Hi All -
Ok, I have to be honest here… I’m getting so many different pieces of advice that I am getting confused.
Many of the things I’ve already attempted I got from reading the forum and following the step-by-step instructions like this one:

How do I connect a Ruida controller with Ethernet?

Setting up a Ruida controller to connect via Ethernet isn’t hard, but it’s not quite as simple as just plugging it in. Follow these steps: 1) Get the IP Address of your computer: For Windows: Open a command prompt (click the Start button, type CMD, and hit enter). Type IPCONFIG and press enter. You’ll see something like this: [image] The one labeled ‘IPv4 Address’ is the interesting part - this is the network address of your computer on your local network. The first 3 groups of numbers …

As many of them were attempted several days ago, I no longer have screen shots to share or settings to tell you.
As for trying to connect Mac/Lightburn to the laser/controller over WiFi, I was following very specific instructions from the Aeon tech I was working with.

I think my best bet now is to start over. Pretend I didn’t do any of these things.
Can we start from scratch and I say:
I ran a USB from my Mac to my Mira 7 with Ruida controller and manually set it up in Lightburn. But it tells me there is no device found. I did it again with versions 9.20 and 9.24.

What should my next move be?