Burned corners of the object

[Rick (Technical Evangelist)]

The following might be worth your review,

Ruida Max/Min power issue

Max Power: The power level to run the laser at Min Power: The power value used for corners, or when moving at low speed (DSP only) Note: On GCode based systems, you only get “Max Power” - the power the laser will use when running at the chosen speed. On DSP systems, you have the additional ‘Min Power’ setting, which is used when traveling at low speed, or when cornering. If you are cutting at a low overall speed (for example, 10 to 20 mm/sec on a CO2 machine) the laser might only ever use th…

@CEVETE

Also, please, where do I set the object to be, for example, 10x10cm and not 9.8x9.8 cm.

I am not confident that I follow this question. You may want to reword, and try to translate again.

You can specify the size of an object using these controls.

You can change the location of an object using the controls just to the left, marked with XPos and YPos.