I have the Omtech 60 w autofocus 700mmx525mm bed.camera is 5mp 150. When I set up my camera for light burn it frames it out nearly 5” off the taxis both side and 2” off the lower x axis. The dot pictrue I used to calibrate said to print at 5.4”x4.1” that seemed small for the machine. I went ahead and set it up by my image when I did the alignment was mirrored. How to I get it to show the image the correct way like I seen in all the videos I watched? Also once I did the image overlay how do I know where I can put material in reference to my overlay?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.