hi all… I state that I tried a search but the forum replies that the searches are temporarily disabled, so I try like this; while I was writing this post, similar topics appeared to me but none similar so, just a question: I have a 20W Atomstack and I would simply like to see the low power laser t…

If you hold the Shift key when framing it will turn on. Otherwise it turns off as a safety measure.

First of all thanks for your answer but pressing or holding the Shift key while framing, nothing happens Do I have to resign myself? (I always turn off the laser when I’m not using it, so I don’t need the safety measure)

Read here: [image] How do I turn on my diode at low power to focus it or frame a job? Resources Diode lasers often don’t have a red-dot pointer like CO2 lasers do, so it is often useful to enable them at low power for focusing or framing. (Please do NOT do this if you hav…

as already written, I already knew the procedure for enabling the crosshair point but reading that answer I also understood how to use the shift key and enable it during framing … it’s much better this way, thanks again

Can i see the laser dot always present?

LightBurn Software Questions

LightBurn (Oz) March 19, 2021, 5:55pm 4

Read here: