Connection of the MKS 32 board to the K40 CO2 type 2 power supply

[parsec (FerAS)]

Check if the bellow threads help:

Urgent help needed! Replacing M2 Nano board with a MKS DLC32

Hi all! I’m in a bit of a pickle! The M2 Nano on my K40 just said goodbye to one of the drivers while cutting a big order. I do have a Two-trees Ts2 with a MKS DLC32 in it and am looking for a reliable resource to adapt this board to my K40 as fast as possible! My LPSU is a bit different than what I am seeing in some tutorials, it has 2 green plus instead of 3, and I am not completely sure of how I must wire the laser negative to my board. Can any good soul please direct me to a post or reliable…

How does this wiring setup look for K40 + MKS DLC32 2.1

Hello, I recently picked up an MKS DLC32 2.1 board to replace the stock board in my K40 laser. I purchased the laser a week ago or so but wasn’t enjoying the Meerk40t work around (cool project though) I’ve removed the digital power control panel and opted to use the touch screen interface with the MKS board. It has a built in test/fire button and I can use my amp meter + set the PSU pot to limit output to the laser so I don’t overdrive it. Below is how I’ve wired the board. It’s working fine…