Hello! New user here and very excited. I’m running Lightburn on OSX, and have managed to get my new Ortur 15W firmware updated and working to do a few simple shapes. However, on some shapes I am seeing a consistent ALARM 3 message on the console. It’s consistent in that it happens in the same place…

GRBL Alarm 3 is “Reset while in motion. Grbl cannot guarantee position. Lost steps are likely. Re-homing is highly recommended.” What are the travel limits of that machine? The “on or near” thing doesn’t count commented out lines, so it’s probably closer to the bottom of the lines you’ve posted, w…

Consistent Alarm 3

Resources Getting Started With LightBurn

Rick (Technical Evangelist) February 27, 2020, 1:59am 4

Grbl-v1.1 grbl Response Messages

Grbl-v1.1 Alarm Messages

Neje Master 2S Grbl cannot guarantee position. Lost steps are likely. Re-homing is highly recommended

AnnoyTools - Alarm3