Good evening, I just tried to get my Creality Falcon A1 Pro up and running with LightBurn RC 2.1. The printer is detected thanks to the profile, but unfortunately I can’t get the camera to work. Is there a trick to this?

[image] SirJuergen: I can’t get the camera to work. Did you add the camera? Or can you explain in detail what doesn’t work? Although the camera is connected over USB, it uses the RNDIS protocol and is therefore only supported in the upcoming version 2.1, and the RC. To add it: Go to “Laser…

Creality Falcon A1 Pro Camera not found in LightBurn 2.1 RC9

LightBurn Hardware Compatibility Cameras

parsec (FerAS) April 15, 2026, 7:27pm 2

Welcome Juergen.
Maybe this can help: