Creality Falcon A1 support

[Aaron.F (Aaron)]

This still sounds like the firmware bug I mentioned.

Please run this test:

@Aaron.F

• Right click in the Console Window, select “Clear Console” and enable “Show All”:

• Enter these commands, one line at a time, and press “Enter” after each:
  $i
$$
$#
?
• Enter M8 in the command box and press Enter. - The Air assist should turn on.
• Entering M8 again, it should stay on as far as I’m concerned.
• Let it run for a couple minutes. - Does it stay on?
• Enter G1 S0 and press enter. - Nothing should happen.
• Finally, enter the M9 command to turn the air assist off.

The air assist should stay on until the M9 command is sent. Kindly let us know, if it behaves otherwise.

Then, right click in the console, “Select All” and copy/paste the full output in a reply here.