Hello all, I need some help. When I try to run an engraving project, the machine stops anywhere between 20% and 60% and either just freezes or returns to home. When I check the console tab it shows streaming either completed or stopped at a certain number. Sometimes after resetting both LightBurn and the machine it will finish the project, however it will start from the beginning and re-burn what has already been burned before. Any help would be greatly appreciated.
Start here:
1 Like
How long is this process, before it fails?
Other helpful stuff:
What kind of laser?
What kind of computer?
How long was the job?
How big was the image?
This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.