Endstops in Totem S 5.5

[berainlb (PY)]

@Carracedo

‎‎The firmware has been sent to me from the Two Trees support department via WeTransfer. ‎
‎ If this is not the correct firmware, where can I get it? ‎

I’m not certain that the firmware is incorrect. But just speculating based on the error message and other symptoms. Did you confirm with Two Trees team that you needed this in order to do enable homing?

I do know that others with Two Trees were able to add limit switches. However, they were unable to save the configuration.

Totem S with Limit Switches / Homing

The unit responds properly when the “Home” button is clicked, moving the laser head to the left, then down to the bottom, but once it completes the homing sequence and I click the “Get Position” button, the X and Y positions show “-299”, not “0” like I’m expecting. Also, I have to execute the $21=1, $22=1, and $23=3 every time I start LightBurn. I can save the settings under Machine Settings as an “.lbset” file, but how do I get LightBurn to load these settings on startup? Thanks!