Engrave - Fill - Scan Vector lines

[LightBurn (Oz)]

The simplest way is to use the offset tool to make another circle around the first one, on the same layer, then set that layer to fill. It will fill the area between them.

Similar to this:

How do I invert (negate) a vector engraving?

If you want to invert a vector engraving (Fill layer) you need to add an outline to it. Think about what happens when you scan a circle, compared to the letter ‘O’. The inner ring of the O toggles the fill. If you add another shape (like a square) outside it, it negates the whole thing: [image] And a slightly different example, this time done by changing the outer line around the design to a ‘Line’, instead of leaving it as part of the Fill layer: [image] In the case above, the design alr…