Error:20 Unsupported or invalid g-code

[MikeyH (Mike Hembrey)]

Never read about this one before, but did find something similar.

Creality Falcon 2 Frame is Incorrect

If I set LightBurn to Current Position and then set the Job Origin to anything but the lower left corner, the machine frames in the wrong place. It always frames as if it were starting from Current Position but with the Job Origin in the lower left corner. I’m using a 22W Creality Falcon 2. I’m using G-Code files instead of a USB connection. Below is a picture of a scrap piece of cardboard I was running tests on to figure out alignment. You can see my pencil marked X, whcih I was trying to hit…

Rather than play 20 questions for now, please upload the Lightburn file you used for these images. I will see if the issue duplicates on my machine.