Files dxf problem

[Rick (Technical Evangelist)]

For LightBurn:

Reset LightBurn to factory settings?

Q: Is there a way to reset LightBurn to “factory default” settings? A: There is. Follow these steps: Run LightBurn Click File => Open Prefs Folder Close LightBurn Delete the contents of the prefs folder (it should be a couple files called prefs.ini and prefs.old) That’s it. When you re-run you’ll be asked to set up your laser again, and everything will be as new.

For the Ruida Controller:

You have not answered my previous question.

@Rick

Is this the controller that came with this laser, or a replacement controller / home-built setup?

When purchasing a laser with a DSP controller installed, the factory making the machine configures the laser controller for you to tell the controller how fast and in what directions to move, where the homing switches are, and so on. They are the best source for the settings used for this system.

If you do not have access to that, we offer this to help with configuring a Ruida: Configuring A Ruida - LightBurn Software Documentation