After the latest update 1.7.06, is suddenly the fill and offset file mode are not working properly anymore. I have a Xtool D1 pro running problem free until this update. I have tried to shut down and restart the computer a couple of times as I have shut down the laser a few times. To rule out any p…

Ok, it works again: I installed a 1.6 version. then installed the configuration file again which i found here: Operate xTool D1 Pro with LightBurn - xTool Support Center . Then updated til the latest version. thank you all for helping

Fill and offset fill mode not working after update to .06

LightBurn Software Questions Licensing

Demus (Joe) February 1, 2025, 11:24pm 3

Just curious, are you using the Lightburn xTool Device type or the one from xTool?
Kinda sounds like an issue that was fixed but weird that it just started.
I would check here:

Just to be sure.