Fill is not filling properly

[JohnJohn (John Johnson)]

Have a look at this:

How do I fix skewed or slanted engraving?

This is an example of a fill followed by a cut around the letter A: [image] The fill is slanted, but the cut appears to be correct. If you have engraving that is slanting to one side, but cuts appear correctly, you likely have your motor pulse step polarity set incorrectly. On Ruida controllers, there’s a setting called ‘PWM Rising Edge Valid’ that you can change for each axis that tells the controller whether the rising edge or falling edge of a step pulse is what the motor driver is lookin…

I don’t usually send folks in this direction.
This is more Ruida controller related than win 10 vs win 11.

On your flag, the error drifts gently from nearly perfect at the bottom to furthest out at the top.
It’s not all over the place like data-noise or lost motion.

Conversely - look for sharp steps or jumps in the skewing to indicate that we should be looking in a different direction.